January 2013 was a big month for the Gougeon Brothers, Inc. Technical Department. This department is responsible for our technical customer service, product development, and quality control. In January this department moved into a completely new building that adjoins our current facility. Continue reading →
Many times each day we get questions about sticking to various substrates. Most questions are on something that we have already tested, so we check our large database and advise on how best adhere to the surface. Other times the request is unique and we are unsure if WEST SYSTEM® Epoxy will stick to it or not. In the event we do not have any experience bonding to a material, we recommend testing adhesion. Many times this means gluing a wood block to the surface, then pulling the Continue reading →
Built in 1957, my 15′ Larson Thunderhawk Jr. is a fiberglass runabout reborn. I launched her into the waters of Grass Lake, in Fox Lake, Illinois in late August 2010. But before this happened, the boat underwent a major restoration. I purchased this boat in August of 2009, after it sat idle for several years, collecting dirt, rainwater, leaves and snow. All that remained was its shell,
I purchased this boat in August of 2009, after it sat idle for several years, collecting dirt, rainwater, leaves and snow. All that remained was its shell, motor, and a rusted trailer. I found a group of Larsen enthusiasts who helped me locate my boat’s original specs, drawings, and
We spend a good amount of time doing everything we can to inform our customers how best to make WEST SYSTEM® epoxy stick to wood, metal, and even plastic, or underwater with the introduction of G/flex 650 and 655. Still, there are many instances when you don’t want the epoxy to stick to one surface or another.
Putting epoxy resin and hardener into a single cartridge was an idea we had years ago, but the technology was never around to do it. Once the technology became available (in the form of a u-TAH chambered cartridge with a mixing wand), we needed to develop a two-part epoxy to go in it.
We chose the characteristics we wanted for this new epoxy: long open time, fast through-cure, full cure overnight, and ability to cure at low temperatures. With these Continue reading →