Tag Archives: power boats

Tunnel Hull numbers

Tunnel Hull

A restoration with WEST SYSTEM Epoxy

By Ed Stubbs

I’m rebuilding and restoring this vintage tunnel hull race boat for Steve Roberge. It was his late father’s boat and he wanted to restore it. We took it to my house to do as a home project.

I love using WEST SYSTEM Epoxy because there is very little odor or product waste, especially when compared to working with polyester resins in less than ideal temperatures. Continue reading

The Phoenix Racing Team Steams On

by Patrick Ropp—GBI Technical Advisor
Epoxyworks 13

Cover Photo: “The last thing I needed to worry about was whether or not my boat would stay intact.

Tiptoeing on the edge of danger, I was crouched down on my knees in the cockpit of my ten-and-a-half foot “sheet of plywood” hydroplane, screaming across the water at speeds reaching 65 mph. Crossing the start line with wide open throttle, I, along with eleven other boats, aimed for the first turn pin. Who will make it there first? With just inches between boats, whitewater from the roostertails engulfed my boat and hammered against my helmet’s visor. These roostertails, which extended thirty feet behind the engine and turn fin, were difficult, almost impossible, to avoid. During this moment of frenzy, I prayed that another hydroplane had not stalled in front of me, or worse . . . flipped. Continue reading